Port MODELACCESS - standard 🛈¶

Use the already activated configuration and the existing program of the automation device.

Stimulation¶

This port has no stimulus capabilities.

Preferred time source/mode: Real-time

Real-time:: To use real-time mode, the Test configuration in the Execution tab must be configured as the source ‘real time’.

Info

The following modes are not supported: Stepwise simulation time, Continuous simulation time

Name	Available if	Default value	Valid values	Type	Description
Device NetId		‘127.0.0.1.1.1’		string	NetId of the automation device
Device port		801		int	Communication port of the automation device. Default TwinCat 2: 801. Default TwinCat 3: 851.
Access variables by handle		☐		bool	Determines, whether access to variable values is to be carried out by handle.
Support for online model querying		☑		bool	(De-)Activates the interface for online querying of model information by the test configuration
Recording
File type for signal recording	Recording	‘MDF’	[‘MDF’, ‘CSV’]	string	File type for signal recording
Max. delay for signal query [ms]	Recording	50		float	Allowed delay when transmitting changed signal values. Increasing this value leads to a delay when reading signals in ecu.test. When setting this value too low, signal recordings may not contain all signal changes, especially when recording multiple signals with high frequent value changes parallel!
Recording mode	Recording	event-based	[event-based, cyclic] Display values: event-based: Event-based cyclic: Cyclic	string	Mode for signal recordings. Event-based: Data points are created when the signal value changes. Cyclic: Data points are created regarding the configured acquisition rate.
Default acquisition rate [ms]	Recording » Recording mode: ‘cyclic’	10		float	Default acquisition rate in milliseconds.

Resets the device

Starts the device

Stops the device