Port SERVICEACCESS - RECORDING-PCAP 🛈¶
Recording in PCAP format
Stimulation¶
This port has no stimulus capabilities.
Properties 🛈¶
Name |
Available if |
Default value |
Valid values |
Type |
Description |
|---|---|---|---|---|---|
Port |
string |
Name of the port inside a network. In Vector Hardware Config, the network-based mode must be activated. |
|||
Filter in BPF format |
‘ether proto \ip’ |
string |
Recording filter. The optional identifier [IP] in square brackets is a variable which will be replaced by the address of the selected adapter when the configuration is loaded. [IP] corresponds to the port’s IP address. VLAN filtering will automatically be applied if activated. |
||
VLAN settings |
‘no tagging’ |
[‘no tagging’, ‘single tagging’] |
string |
Used VLAN setting |
|
VLAN-VID |
1 |
int |
Integer, only used if VLAN tagging is enabled |
||
Disable LibPcap buffering |
☐ |
bool |
Disable internal LibPcap buffering |
||
Receive buffer size |
1000 |
int |
Number of messages which can be recorded in the receive buffer (ring buffer) |
||
Automatic data reception on test run |
☑ |
bool |
Only operative if on the left for ‘Start’ either ‘Always’ is chosen, or ‘If necessary’ and the port is in use in the test configuration. |
||
Path / file name for the PCAP/PCAPNG output file |
Automatic data reception on test run |
string |
PCAP or PCAPNG file (with absolute path). Recording is done into this file. Leave blank if no recording is desired. |
||
IP address |
string |
IP address of the port, will be replaced for [IP] in the filter string |
Jobs 🛈¶
ClearReceiveBuffer¶
Clears the ecu.test high-level receive buffer. Low-level buffers in the driver are not cleared.
StartReceiving¶
Starts manual data receiving
Parameterization
Parameter
Name |
Available if |
Default value |
Valid values |
Type |
Description |
|---|---|---|---|---|---|
FilterString |
‘ether proto \\ip’ |
string |
Recording filter. The optional identifier [IP] in square brackets is a variable which will be replaced by the address of the selected adapter when the configuration is loaded. [IP] corresponds to the port’s IP address. VLAN filtering will automatically be applied if activated. |
||
PcapFileName |
string |
PCAP or PCAPNG file (with absolute path). Recording is done into this file. Leave blank if no recording is desired. |
|||
VlanVid |
‘Default’ |
string |
Integer, Default if port setting should be used, only evaluated if VLAN is configured |
StopReceiving¶
Stops data receiving manual