Port SERVICEACCESS - ARP 🛈¶
Responds on ARP requests
Stimulation¶
This port has no stimulus capabilities.
Properties 🛈¶
Name |
Available if |
Default value |
Valid values |
Type |
Description |
|---|---|---|---|---|---|
Network name |
string |
Name of the network as defined in SIL-Kit Config yaml. |
|||
Controller name |
string |
Name of the controller as defined in SIL-Kit Config yaml. |
|||
Filter in BPF format |
‘ether proto \arp’ |
string |
Filter for the ARP protocol. The identifier [IP] that is enclosed in square brackets describes a variable which will be replaced when loading the configuration. [IP] correspond to the value in the port settings. VLAN filtering is applied automatically. |
||
VLAN settings |
‘no tagging’ |
[‘no tagging’, ‘single tagging’] |
string |
Used VLAN setting |
|
VLAN-VID |
1 |
int |
Integer, only used if VLAN tagging is enabled |
||
Disable LibPcap buffering |
☐ |
bool |
Disable internal LibPcap buffering |
||
Receive buffer size |
1000 |
int |
Number of messages which can be recorded in the receive buffer (ring buffer) |
||
Automatic data reception on test run |
☑ |
bool |
Only operative if on the left for ‘Start’ either ‘Always’ is chosen, or ‘If necessary’ and the port is in use in the test configuration. |
||
Path / file name for the PCAP/PCAPNG output file |
Automatic data reception on test run |
string |
PCAP or PCAPNG file (with absolute path). Recording is done into this file. Leave blank if no recording is desired. |
||
Default source MAC address |
‘02:00:4C:4F:4F:50’ |
string |
Default MAC address to be used for Ethernet frames |
||
Default source IP address |
string |
Default IP address to be used for IP packets |
|||
VLAN-PCP |
0 |
int |
Integer, only used if VLAN tagging is enabled |
||
VLAN-CFI |
0 |
int |
Integer, only used if VLAN tagging is enabled |
Jobs 🛈¶
ClearReceiveBuffer¶
Clears the ecu.test high-level receive buffer. Low-level buffers in the driver are not cleared.
StartReceiving¶
Starts manual data receiving
Parameterization
Parameter
Name |
Available if |
Default value |
Valid values |
Type |
Description |
|---|---|---|---|---|---|
FilterString |
‘ether proto \\arp’ |
string |
Filter for the ARP protocol. The identifier [IP] that is enclosed in square brackets describes a variable which will be replaced when loading the configuration. [IP] correspond to the value in the port settings. VLAN filtering is applied automatically. |
||
PcapFileName |
string |
PCAP or PCAPNG file (with absolute path). Recording is done into this file. Leave blank if no recording is desired. |
|||
VlanVid |
‘Default’ |
string |
Integer, Default if port setting should be used, only evaluated if VLAN is configured |
StopReceiving¶
Stops data receiving manual