Port LOGGING - DLT-VERBOSE 🛈¶
Access to DLT verbose messages
This port is only available if Npcap is installed.
Stimulation¶
This port has no stimulus capabilities.
Properties 🛈¶
Name |
Available if |
Default value |
Valid values |
Type |
Description |
|---|---|---|---|---|---|
Active mode |
☑ |
bool |
When this option is selected, ecu.test actively connects to the site. If the setting is not selected, ecu.test does not establish a Connection itself. Rather, only data addressed to another tool is read (passive mode). |
||
DLT TCP auto reconnect timeout [sec] |
Active mode: ‘True’ |
float |
ecu.test will automatically restart the DLT TCP connection if no new DLT messages arrive within the configured number of seconds. An empty value for the timeout switches the auto reconnect feature off. |
||
Pre-recording circular buffer |
Active mode: ‘True’ |
0 |
int |
Since the recording gets started only a short time after the connection to the ecu is established, even with auto-start/stop, messages sent by the ECU only once immediately after the connection is made, can be lost. With this setting, the recording can be “extended forward” by the specified number of messages, in order to include these initial messages. |
|
Network interface card |
Active mode: ‘False’ |
[‘’] |
string |
Used network interface card |
|
VLAN settings |
Active mode: ‘False’ |
‘no tagging’ |
[‘no tagging’, ‘single tagging’] |
string |
Used VLAN setting |
VLAN-VID |
Active mode: ‘False’ |
1 |
int |
Integer, only used if VLAN tagging is enabled |
|
Logger protocol |
Active mode: ‘False’ |
[, PLP/TECMP, ASAM CMP] |
string |
Use a logger protocol such as ASAM CMP. The port can then only be used for reading. Ethernet frames contained in the logger messages are extracted and the filter in BPF format (if specified) is applied to these frames. |
|
Device-IDs / Probe-IDs |
Active mode: ‘False’ » Logger protocol: ‘PLP/TECMP’ |
string |
Identifiers of the devices / probes: empty if no filtering based on device / probe IDs is required; several can be separated by commas. |
||
Device and Stream IDs |
Active mode: ‘False’ » Logger protocol: ‘ASAM CMP’ |
string |
Identifiers of the devices and streams as a list of tuples, each consisting of device ID and stream ID, e.g.: (1,2),(3,4). Leave empty if no filtering based on device and stream ID is needed. |
||
Interface-IDs / Bus-Spec-IDs |
Active mode: ‘False’ » Logger protocol: ‘PLP/TECMP’ |
string |
Identifiers of the interfaces / bus specs: empty if no filtering based on bus interface / spec IDs is required; several can be separated by commas. |
||
Interface IDs |
Active mode: ‘False’ » Logger protocol: ‘ASAM CMP’ |
string |
Identifiers of the interfaces: empty if no filtering based on interface IDs is required; several can be separated by commas. |
Jobs 🛈¶
Reconnect¶
In Active Mode, reconnects and clears the message buffers.
Parameterization
Return value
Name |
Available if |
Default value |
Valid values |
Type |
Description |
|---|---|---|---|---|---|
result |
False |
[False, True] |
bool |
Returns True if the connection was successfully established |