Port MODELACCESS - CAPTURE-ANALOG 🛈¶
Port for reading the current or voltage of capture module channels via PLP/TECMP or ASAM CMP
This port is only available if Npcap is installed.
Stimulation¶
This port has no stimulus capabilities.
Supported execution modes¶
See also: Temporal behaviour: Real time and simulation time modes
Preferred time source/mode: Real-time
- Real-time:
To use real-time mode, the Test configuration in the Execution tab must be configured as the source ‘real time’.
Info
The following modes are not supported: Stepwise simulation time, Continuous simulation time
Properties 🛈¶
Name |
Available if |
Default value |
Valid values |
Type |
Description |
|---|---|---|---|---|---|
Physical Layer ❲Network Access❳ |
|||||
Network interface card |
string |
The network interface card or network adapter to be used for receiving network packets |
|||
Logger Protocol Settings |
|||||
Logger protocol |
ASAM CMP |
[ASAM CMP, PLP/TECMP] |
string |
Use a logger protocol such as ASAM CMP. Ethernet frames contained in the logger messages are then extracted. |
|
Device Configuration |
Logger protocol: ‘ASAM CMP’ |
|
text |
configuration (YAML format) of deviceIds, streamIds, interfaceIds, and an arbitrary name for each combination |
|
Device Configuration |
Logger protocol: ‘PLP/TECMP’ |
|
text |
configuration (YAML format) of deviceIds, interfaceIds, and an arbitrary name for each combination |
|
Outer VLAN mode |
disable |
[disable, single tagging, single tagging (any ID)] |
string |
If set to ‘single tagging’, take an additional IEEE 802.1Q tag outside the logger protocol into account and filter by the specified VLAN id; or if set to ‘single tagging (any ID)’, the tag itself must be present but the VLAN id is not relevant. |
|
Outer VLAN id |
Outer VLAN mode: ‘single tagging’ |
0 |
int |
Filter incoming packets by this VLAN id, so only packets with a matching VLAN id will pass. |