Port ELECTRICERRORSIM - CANWAY¶
CAN-Controller for CANWAY-FIU
Stimulation¶
This port has no stimulus capabilities.
Properties 🛈¶
Name |
Available if |
Default value |
Valid values |
Type |
Description |
|---|---|---|---|---|---|
Channel number |
‘1’ |
string |
Selection of channel number if there is more than one controller of same type. |
||
Bit rate |
‘500KB’ |
[‘20KB’, ‘50KB’, ‘83.333KB’, ‘100KB’, ‘125KB’, ‘250KB’, ‘500KB’, ‘800KB’, ‘1000KB’] |
string |
Bit rate |
|
Configuration file |
string |
Path to the configuration file of the EES port. Path has to be either absolute, or relative to the EES directory. If <auto>, the configuration file referenced by the TCF will be used. Otherwise this setting will take precedence over the path that is configured in the TCF. |
|||
Clear errors at end of test case |
☐ |
bool |
“True” enables automatic deletion of all electrical errors at the end of each test case and restoring the error-free state of the EES hardware. Select “False” to make electrical errors not deleted by the test case persist beyond the end of the test case. |
||
Mode |
Standard |
[Standard, Extended, All] |
string |
Addressing mode (Standard = 11bit, Extended = 29bit) |
|
Listen only |
☐ |
bool |
Controller is running in passive mode. Automatic ACK is disabled, and sending CAN frames is not possible. |
||
Receive error frames |
☐ |
bool |
Receive error frames |
||
Placeholder value for automatic E2E calculation |
int |
Whenever this value is specified for an E2E signal (e.g. CRC), upon transmission ecu.test automatically replaces it with the correct, calculated value. The purpose of this option is to allow transmission of arbitrary fixed values (unequal to the value chosen here). Leaving this option empty completely disables the feature.For more information see the documentation at Tool categories - Automatic E2E calculation |
|||
Transmission confirmation |
☐ |
bool |
Activates acknowledged sending. Bus-Write test steps and Send tool jobs block until the message was successfully transferred on the bus or the confirm timeout expired. |
||
Timeout for transmission confirmation |
1000 |
int |
Period in miliseconds in which a message has to be sent successfully. Otherwise an error is created. (must not be larger than 64535ms). Is only used in active confirm mode. |
Jobs 🛈¶
ResetErrors¶
Clears all errors by appending an empty ErrorSet to the ErrorConfiguration and triggering that ErrorSet.