Port MODELACCESS - flash¶
Flash the device with a configuration file *.tsm) and a program file (.pro)
Stimulation¶
This port has no stimulus capabilities.
Supported execution modes¶
See also: Specifics of time modes
Preferred time source/mode: Real-time
- Real-time:
To use real-time mode, the Test configuration in the Execution tab must be configured as the source ‘real time’.
Info
The following modes are not supported: Stepwise simulation time, Continuous simulation time
Properties 🛈¶
Name |
Available if |
Default value |
Valid values |
Type |
Description |
|---|---|---|---|---|---|
Device NetId |
‘127.0.0.1.1.1’ |
string |
NetId of the automation device |
||
Device port |
801 |
int |
Communication port of the automation device. Default TwinCat 2: 801. Default TwinCat 3: 851. |
||
Access variables by handle |
☐ |
bool |
Determines, whether access to variable values is to be carried out by handle. |
||
Recording |
|||||
File type for signal recording |
Recording |
‘MDF’ |
[‘MDF’, ‘CSV’] |
string |
File type for signal recording |
Max. delay for signal query [ms] |
Recording |
50 |
float |
Allowed delay when transmitting changed signal values. Increasing this value leads to a delay when reading signals in ecu.test. When setting this value too low, signal recordings may not contain all signal changes, especially when recording multiple signals with high frequent value changes parallel! |
|
Recording mode |
Recording |
event-based |
[event-based, cyclic] Display values:
|
string |
Mode for signal recordings. Event-based: Data points are created when the signal value changes. Cyclic: Data points are created regarding the configured acquisition rate. |
Default acquisition rate [ms] |
Recording » Recording mode: ‘cyclic’ |
10 |
float |
Default acquisition rate in milliseconds. |
|
TwinCAT program file |
string |
Local file that contains the application to load (*.pro). Only supported by TwinCAT 2. |
|||
TwinCAT configuration file |
string |
Local file containing the configuration to be loaded (*.tsm/*.wsm) |
Jobs 🛈¶
ResetDevice¶
Resets the device
StartDevice¶
Starts the device
StopDevice¶
Stops the device