Port MODELACCESS - CAPTURE-ANALOG

Port for reading the current or voltage of capture module channels via PLP/TECMP or ASAM CMP

This port requires a PCAP driver to be installed.

Stimulation

This port has no stimulus capabilities.

Supported execution modes

See also: Specifics of time modes

Preferred time source/mode: Real-time

Real-time:

To use real-time mode, the Test configuration in the Execution tab must be configured as the source ‘real time’.

Info

The following modes are not supported: Stepwise simulation time, Continuous simulation time

Name

Available if

Default value

Valid values

Type

Description

Physical Layer ❲Network Access❳

Network interface card

[ONLINE]

string

The network interface card or network adapter to be used for receiving network packets

Logger Protocol Settings

Logger protocol

ASAM CMP

[ASAM CMP, PLP/TECMP]

string

Use a logger protocol such as ASAM CMP. Ethernet frames contained in the logger messages are then extracted.

Device Configuration

Logger protocol: ‘ASAM CMP’

  • name: example_channel

    deviceId: 0x12

    streamId: 0x3

    interfaceId: 0x456789

text

configuration (YAML format) of deviceIds, streamIds, interfaceIds, and an arbitrary name for each combination

Device Configuration

Logger protocol: ‘PLP/TECMP’

  • name: example_channel

    deviceId: 0x123

    interfaceId: 0x456789

text

configuration (YAML format) of deviceIds, interfaceIds, and an arbitrary name for each combination

Outer VLAN mode

disable

[disable, single tagging, single tagging (any ID)]

string

If set to ‘single tagging’, take an additional IEEE 802.1Q tag outside the logger protocol into account and filter by the specified VLAN id; or if set to ‘single tagging (any ID)’, the tag itself must be present but the VLAN id is not relevant.

Outer VLAN id

Outer VLAN mode: ‘single tagging’

0

int

Filter incoming packets by this VLAN id, so only packets with a matching VLAN id will pass.